Use Pool Supplies Canada Fast Acting Stabilizer to protect and stabilize chlorine against destruction by sunlight. Easy and simple to use, using a stabilizer will save you money since less disinfectant will be needed over time. The rapid solubility of Pool Supplies Canada Fast Acting Stabilizer establishes chlorine protection quickly.

Directions for Use:

1. Use a test kit to determine the stabilizer concentration in the swimming pool water

2. If the pool is new, has just been refilled, or has no stabilizer, add 300g of Stabilizer per 10,000 L of water to establish a desired level of 20 to 30 ppm

3. If there is less than 20 ppm of stabilizer, add Stabilizer until a level of 20 to 30 ppm is achieved. 75g of Stabilizer per 10,000 L of water will increase levels by approximately 8 ppm

Always maintain a chlorine residual of 1.0 - 3.0 ppm, and a pH level between 7.2 - 7.8. Add Stabilizer slowly into skimmer or, if desired, pre-dissolve in a pail of warm water and then add directly to the skimmer. Be sure your filter is clean and recirculate water continuously for 12-24 hours after adding to dissolve completely

NOTE: Save money by keeping your stabilizer levels between 25-50 ppm.

Warranty Coverage: Pool Supplies Canada Chemicals come with a 30 Day Limited Manufacturers Warranty.

Start a Warranty Claim:To begin a claim please email customerservice@poolsuppliescanada.ca with a photo showing the defect(s)/issue with your Pool Supplies Canada Chemical and include a brief explanation of what occurred.