Why Switch to the DIVE System?

Tired of buying pool chemicals? Do you wish balancing your pool chemicals was easy? The DIVE system is the solution to these problems and more. DIVE is a self-powered all-in one smart system that will save you time and money, while allowing you to control your water quality through an app.

The DIVE System turns salt water into chlorine and copper algaecide, which means you never have to buy chemicals again. Then, through energy which the turbine generates itself, the DIVE system disperses the chemicals it creates throughout your pool, improving your water quality. You can adjust the levels of chlorine and algaecide separately from the free app to get the water exactly the way you want it.

Self-Powered Turbine Won’t Cost You Electricity

It’s hard to believe that such a powerful generator is tucked into a 16.5-inch system, but it is. Four years of research and development went into the creation of this amazing and efficient turbine. The result is that it doesn’t need to be connected to any electrical outlet.

Instead, the system uses the movement of your pool’s water in your pool lines to generate all of the electricity it needs. Not only do you save on utilities by using this system instead of an electrical one, you also save on initial installation costs, because you don’t need an electrician to come in and set it up!

Never Buy Chlorine or Algaecide Again

Who isn’t tired of checking on their pool chemical stockpile, measuring out doses, and spending money on yet more chlorine? The Dive system will save you all that fuss by turning normal table salt into both the chlorine and copper algaecide you need to have a safe and healthy pool. That means you don’t have to make any more trips to the store or even handle these chemicals. Instead, the breakthrough hybrid electrolytic cell produces everything you need.

Adjust Chlorine and Algaecide Levels from the App

The Dive system uses your home’s Wifi to connect with the free app you use to control it. From the app you can monitor your pool’s water quality and increase or reduce levels of chlorine and algaecide. You can be poolside and check on the app from your phone, or you can check on it from your laptop inside, it doesn’t matter. The Dive system will also let you know the temperature of your pool and the water flow rate, right from the app.

Simple Installation

When you’re ready to switch over to the Dive system, it’s simple. The unit comes with everything you need to install it, even the plumbing tape! Installation is just a matter of cutting a spot in your pool’s PVC piping and attaching the system and its included fittings into your pool’s plumbing system.

Stop spending all your time maintaining your pool, buying chemicals, monitoring their levels, and spend more time enjoying your pool! Switch over to the DIVE system today. DIVE is available exclusively online from Pool Supplies Canada.

How to Install the DIVE System:

Step One

The DIVE System will be incorporated into your existing pool PVC pipe, in your pool heater line. In the existing pipe, measure a 16-inch length and cut it out. Remember: measure twice, cut once!

Step Two

Discard the 16-inch piece you cut out. Attach reducers to each end of the gap. Use the provided cement glue and then plumbing tape to secure the reducers.

Step Three

Ensure the DIVE Sanitizer Salt/Mineral Cell is installed into the system. Attach plumbing unions to the DIVE System and tighten. With the unions on, the DIVE System should fit snugly in the remaining gap in your line.

Step Four

Secure the DIVE System and unions to the reducers with cement glue and plumbing tape.

Step Five

Turn on the system. Have your WiFi password handy so you can connect the system to your network. At this point, you may want to download the DIVE System App so you can start monitoring your pool levels.

Step Six

You’ll now need to add a few bags of salt to your pool so that the DIVE System can begin turning it into chlorine and algaecide.

Share This Blog Post