12 x 24 ft Rectangle Basic Pool Winter Cover

Our covers are Laminated polyethylene sheeting woven with thick, high-density polyethylene stitching that ensures superior tensile strength and durability. All covers are manufactured with a high weave count and are treated to provide maximum resistance to damaging ultraviolet rays, inhibit deterioration, prevent tearing, and increase the cover's longevity and lifespan.

For instructions on how to Winterize your inground pool, click here.

Not for use with Soft Sided Pools (Intex, Bestway, etc).

Features:

• Keep your pool free of dirt, leaves, and debris
• Stop chemical loss through evaporation
• Prevent algae growth over the winter season
• Protects your pool from winter damage
• Makes pool opening in the spring simple and clean

Specifications:

• Blue / Black in Colour
• Woven with thick, high-density polyethylene stitching
• Both sides of the cover have 3.24 oz lamination for UV resistance and increased lifespan
• Every cover comes with additional material (true 6 ft overhang) to ensure your pool is fully covered during the off season - for example, a 12 x 24 foot cover would actually measure 18 x 30 feet in size

Warranty Coverage: Basic Blue Winter Covers come with a 8 Year Limited Prorated Manufacturers Warranty. The manufacturer of this cover warrants this cover against defects on workmanship and materials. This warranty will be void if the cover is damaged as a result of improper installation or use, or if damage is a result of ice, wind, low water level or damage caused by animals. Warranty does not cover any labour charges, cost of lost water or chemicals, or any other damages that may occur.

Start a Warranty Claim:To begin a claim please email customerservice@poolsuppliescanada.ca with a photo showing the defect(s)/damage to your Basic Blue winter cover and include a brief explanation of what occurred.

WINTER COVER
INSTALLATION INSTRUCTIONS

General Procedures

1. Since the cover is designed to rest on the pool’s water, it is important to be sure your pool in not leaking prior to installation.


2. Your cover is made from extremely strong and durable material. However, it is required that your cover be protected from sharp corners, rough edges, or any hard surfaces that may cause abrasion. Padding such as old towels, foam remnants or other similar materials are recommended.


3. It is important that covers be installed properly and snugly so that the wind will not cause damage to the cover by getting underneath, causing it to billow or flap.

Inground Pool Installation

1. Be sure that the cover will be supported by the water in the pool and that the cover is not in direct contact with any sharp rough or abrasive surfaces.


2. Lower the water level in your pool below the skimmer (No more than 18 inches below the coping).


3. Place the cover on the ground and spread evenly over the pool.


4. Insert unfilled water bags into the waterbag loops (for covers without loops, lay the water bags directly on to the outside perimeter of the cover).


5. The water bags must cover the entire perimeter of the cover to prevent wind from getting under the cover and causing the cover to billow or flap. Caution: such billowing or flapping in the wind can cause serious damage to your cover, so be sure the waterbags are placed end-to-end.


6. Fill the waterbags. If you are in an area of extreme cold, fill the waterbags only half full to allow for ice expansion.